This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. To set up, open the Google Assistant or Google Home app, search for theĬ by GE action, follow the setup instructions.įCC Compliance Statement Compliance Notice: To set up, open the Alexa app, search for the C by GE skill, follow the setup instructions. You’ve completed the Smart Switch installation. Go to /switch-support for more troubleshooting.Turn power off at the breaker, return to the switch to confirm the wires are securely and properly wired according to the installation guide.Check that power to the switch is on at the breaker.Check that the air gap switch is depressed.The light ring will not illuminate if wired incorrectly. Max load rating 150W LED and 450W incandescent/halogen. The light ring will flash red if the circuit is overloaded.
The light ring will continuously flash blue until the switch is added to the C by GE app.
Screw on the faceplate bracket, then snap the faceplate cover onto the bracket.Īfter the switch is secured and faceplate mounted, turn the power back on at the circuit breaker box.Īt the switch, the light ring will flash blue indicating the device is wired correctly and the device is in setup mode. Using a Phillips screwdriver and the screws provided, secure the switch to the wall until level and flush. Neatly push the wires back into the box, rotating the switch so it’s oriented according to the image. Pull gently on wires to test the connection. Cap the 3-way/multi-way traveler wire (if applicable).įor a 3-way switch setup, visit /switch-support Attention: Incorrectly connecting the Neutral or Ground wire from the wall to the Line or Load wire on the switch will damage the product. Connect the ground (green) wire on the switch with the ground (green label) wire from the wall. Connect the load (red) wire on the switch with the load (red label) wire from the wall. Connect the line (black) wire on the switch to the line (black label) wire from the wall. Connect the neutral (white) wire on the switch to the neutral (white label) wire from the wall. Disconnect wires and remove the existing switch. If you don’t have either wire, the C by GE switch is not compatible. Before disconnecting the wires from the wall, label each with the provided wire labels. Use voltage tester on the black wires to confirm power to the switch is off (recommended). Remove the existing wall plate and switch from the wall. Now, follow these setup steps for a single gang switch. Test existing switch by toggling switch on/off, ensuring lights do not turn on. 
Turn off the power for the switch located at the circuit breaker box.For in-depth instructional videos and a guided tour through the installation, go to /switch-support.
0 kommentar(er)
