easetrio.blogg.se

• #USE TFTP CLIENT ON MAC TO FIX READYNAS SERIAL#

For simplicity's sake, you can assume "192.168.1.x" will function. If pinging 192.168.1.1 does not work, check the IP Address of your computer and make sure it is assigned an IP address in the subnet of the router IP. To see if this is possible in your situation, connect your computer with the router using a wired connection and try pinging it. During start-up, the router will pause to accept a temporary firmware upload via TFTP. In the event that the hard reset did not work, there is a way to re-flash the router. Step 1: Finding IP Address and Pinging the Router Disconnect power cord for another 10 secs and then reconnect.Release the reset button and give the router about 10 secs to resettle.Still hold the reset button for another 30 secs.Hold the reset button for another 30 secs.Without releasing reset button, disconnect power cord.Disconnect the router from all cables except the power cable.You follow these instructions at your own risk! Try a Hard Reset First

#USE TFTP CLIENT ON MAC TO FIX READYNAS SERIAL#

If these directions are not followed exactly, you might be forced to use the serial console to recover your router.

Note: Read these directions carefully from beginning to end, twice, then execute very carefully. I've made some changes to the original post as you can see below. It works with v8 and v9 - don't know what about previous versions. You may already know that you can recover your WGR614L with a USB-TTL cable (serial console.)īefore you try to recover your router with TTL cable, however, you can try this (I've found it on the NETGEAR forums and tried by myself). It's happened to all of us at some point - you flash your router with experimental or new firmware and find that something gets corrupted or you have a bad firmware build.